Hydraulic valves control and direct the oil from the time it leaves , the pump until it starts on its return to the reservoir in a hydraulic circuit. The relief valve is almost always the first one encountered by the oil after it leaves the pump. From that point on throughout the circuit, the type of valve employed depends upon the design of the circuit. In a very simple circuit the second and only other valve used will probably be the master control valve. In a complex circuit the oil may flow through a sequence valve, master control valve, reducing valve, flow control valve, check valve and several others before it finally returns to the reservoir.

All of our hydraulic directional control valves can be sized to your current system, or to a system you are in the process of building. Our large inventory allows us to get the hydraulic control valves to you promptly...

Spool Monoblock Hydraulic Direct Control Valve Ways 4 NPT Inlet/Outlet 3/4 Inch Flow Capacity 25 GPM Maximum Pressure 3000 PSI NPT Port 1/2 Inch Relief Valve Range 1500-3000 PSI Factory Preset Relief Valve Setting 2000 PSI @ 10 GPM Spool Action Spring Center to Neutral and 4th Position Detent Spring Center to Neutral Spools 2 Height 3 1/4 Inches Length 10 15/16 Inches Width 7 5/8 Inches

Spool Monoblock Direct Control Valve Ways 4 NPT Inlet/Outlet 3/4 Inch Flow Capacity 20 GPM Maximum Pressure 3000 PSI NPT Port 1/2 Inch Relief Valve Range 1000-2750 PSI Factory Preset Relief Valve Setting 1500 PSI @ 12 GPM Spool Action 3 Position Detent Spools 1 Height 2 3/8 Inches Length 8 Inches Width 3 7/8 Inches

• Compact construction. Low pressure drop.
• Long service life. High efficiency.
• Choice of various operation methods, such as manual, pneumatic, hydraulic, and electro-hydraulic.
• Choice of various ports and circuit valves.
• Spring return.
• High accuracy spool is hardened for long term accuracy.
• Sub-plate mounting.
• Handle shift operation.